The following is an overview of the user manual for the Z-Wave product Ss302-eu (SS302-EU)from Enblink. To view other Z-Wave products and manuals from Enblink follow that link.
Overview
Security
As a Z-Wave Plus certified product, Ss302-eu supports Z-Wave S2 security. The following security modes are directly supported:
Features
Enblink describes Ss302-eu as having the following features:
- Color
- Communications Connections
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
In setting app, enter into following menu.
""Advanced Z-Wave > Join/Leave""
In mobile app, enter into following menu.
""PhoneApp > Device Management > Menu (Inclusion) > Z-Wave""
In mobile app, enter into following menu.
""PhoneApp > Device Management > Menu (RESET)""
Factory reset Ss302-eu
In setting app, enter into following menu.
""About Enblink > Factory reset""
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Ss302-eu from Enblink is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Ss302-eu and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.