The following is an overview of the user manual for the Z-Wave product In-Wall Smart Toggle Switch (46202/ZW4009)from Enbrighten. To view other Z-Wave products and manuals from Enbrighten follow that link.
Overview
Security
As a Z-Wave Plus certified product, In-Wall Smart Toggle Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Enbrighten describes In-Wall Smart Toggle Switch as having the following features:
- Neutral Wire Required
- Z-Wave Scene Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Follow the instructions for your Z-Wave certified controller to remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press and release the top or bottom of the wireless smart switch (rocker).
Factory reset In-Wall Smart Toggle Switch
1. Quickly press ON (top) button three times then immediately press the OFF (Bottom) button three times. The LED will flash ON/OFF five times when completed successfully. Note: This should only be used if your network’s primary controller is missing or otherwise inoperable.
SmartStart location
SmartStart QR code's location as follows: The controller’s app will indicate if it has discovered the switch. If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the side of the box or the QR code label on the product (see Figure 1). Enter the 5-digit code.
1. Follow the instructions for your Z-Wave certified controller to add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press and release the top or bottom of the wireless smart switch (rocker).
Please note that this is a user manual In-Wall Smart Toggle Switch from Enbrighten is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Toggle Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.