The following is an overview of the user manual for the Z-Wave product LED Bulb (52190/ZW7105)from Enbrighten. To view other Z-Wave products and manuals from Enbrighten follow that link.
Overview
- Control lights remotely and save energy
- Compatible with smart home systems supporting Z-Wave
- 60 Watt equivalent light (750 lumens)
- Consumes only 9 watts of power
- 2700K soft light with frosted glass
- Instant ON and fully dimmable
- Functions as a Z-Wave signal repeater
- Z-Wave Plus certified
Security
As a Z-Wave Plus certified product, LED Bulb supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Enbrighten describes LED Bulb as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the side
of the box or the QR code label on the product (see Figure 1).
1. Follow the instructions for your Z-Wave certified controller
to remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, turn
bulb OFF, then ON three times. The smart bulb flashes
twice when removed from the network.
Adding your device to a Z-Wave network
1. When initially powered, the bulb is in SmartStart inclusion mode. If your hub supports SmartStart, scan the
QR code.
2. To change to classic inclusion mode, turn bulb OFF, then ON three times. The bulb rapidly flashes four
times to indicate classic mode.
3. To change back to SmartStart inclusion mode, turn the bulb OFF, then ON three times. The bulb rapidly
flashes six times to indicate SmartStart mode.
NOTE: The bulb attempts to connect in either inclusion
Factory reset LED Bulb
To return your smart bulb to factory defaults
Starting with the bulb on, cycle the wall switch OFF/ON
four times.
1. Turn the switch off, pause one second, then turn back ON.
2. Repeat three times (four times total).
3. The smart bulb flashes twice when reset.
Please note that this is a user manual LED Bulb from Enbrighten is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have LED Bulb and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.