The following is an overview of the user manual for the Z-Wave product Z-Wave Plus In-Wall Smart Switch, White and Light Almond Paddles, 700S (58433/ZWA4011)from Enbrighten. To view other Z-Wave products and manuals from Enbrighten follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Plus In-Wall Smart Switch, White and Light Almond Paddles, 700S supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Enbrighten describes Z-Wave Plus In-Wall Smart Switch, White and Light Almond Paddles, 700S as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Switch Load Capacity Watts
- Switch Type
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 1, box 4
Adding your device to a Z-Wave network
1. Follow the instructions for your Z-Wave certified
controller to add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press the
top or bottom of the wireless smart switch (r
To remove and reset the device
1. Follow the instructions for your Z-Wave certified controller
to remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press
the top or bottom of the wireless smart switch (r
Factory reset Z-Wave Plus In-Wall Smart Switch, White and Light Almond Paddles, 700S
To return your switch to factory defaults:
Pull the airgap switch. Press and hold the bottom button, push the airgap switch in and continue holding the bottom button for 10 seconds. The LED will flash once each of the 8 colors then stop.
NOTE: This
Please note that this is a user manual Z-Wave Plus In-Wall Smart Switch, White and Light Almond Paddles, 700S from Enbrighten is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus In-Wall Smart Switch, White and Light Almond Paddles, 700S and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.