The following is an overview of the user manual for the Z-Wave product Z-Wave Plus In-Wall Smart Switch, White Toggle, 700S (58436/ZWA4012)from Enbrighten. To view other Z-Wave products and manuals from Enbrighten follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Plus In-Wall Smart Switch, White Toggle, 700S supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Enbrighten describes Z-Wave Plus In-Wall Smart Switch, White Toggle, 700S as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Switch Load Capacity Watts
- Switch Type
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 1, box 4
Adding your device to a Z-Wave network:
1. Follow the instructions for your Z-Wave certified controller to add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press up and release the toggle.
To remove and reset the device
1. Follow the instructions for your Z-Wave certified controller to remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press up and release the toggle.
Factory reset Z-Wave Plus In-Wall Smart Switch, White Toggle, 700S
To return your switch to factory defaults:
Pull the airgap switch. Press and hold the bottom button, push the airgap switch in and continue holding the bottom button for 10 seconds. The LED will flash once each of the 8 colors then stop.
NOTE: This should only be used if your network’s primary controller is missing or otherwise inoperable.
NOTE: SmartStart enabled products can be added into a Z-Wave network by scanning the QR code on the product with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically within 10 minutes of being switched on in the network vicinity.
Please note that this is a user manual Z-Wave Plus In-Wall Smart Switch, White Toggle, 700S from Enbrighten is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus In-Wall Smart Switch, White Toggle, 700S and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.