The following is an overview of the user manual for the Z-Wave product Z-Wave Plus In-Wall Tamper Resistant Smart Outlet,700S (58449/ZWA1003)from Enbrighten. To view other Z-Wave products and manuals from Enbrighten follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Plus In-Wall Tamper Resistant Smart Outlet,700S supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Enbrighten describes Z-Wave Plus In-Wall Tamper Resistant Smart Outlet,700S as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Switch Type
- Switch Load Capacity Current
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 1 , Left : Adding your device to Zwave network
1. Follow the instructions for your Z-Wave certified controller to add a device to
the Z-Wave network.
2. Once the controller is ready to add your device, press the program button.
1.Follow the instructions for your Z-Wave certified controller to remove a device
from the Z-Wave network.
2. Once the controller is ready to remove your device, press the program button.
Factory reset Z-Wave Plus In-Wall Tamper Resistant Smart Outlet,700S
Press the program button three times, then, press and hold the button for at
least three seconds. The LED blinks five times to confirm.
Please note that this is a user manual Z-Wave Plus In-Wall Tamper Resistant Smart Outlet,700S from Enbrighten is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus In-Wall Tamper Resistant Smart Outlet,700S and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.