The following is an overview of the user manual for the Z-Wave product In-wall Smart Meter Dimmer Switch (ZW500DM)from Enerwave Green Automation. To view other Z-Wave products and manuals from Enerwave Green Automation follow that link.
Overview
dim brightness control replacement of regular switch, controlling incandescent,
dimmable LED and CFL. This ZW500DM dimmer switch is fully compatible with
other Z-Wave certified devices, provides programmable function creating a perfect ambiance such as scenes,association,schedule event,etc. Also it can be added to most Z-Wave compliant controllers. This ZW500DM dimmer works with ZW3K 3-Way Auxiliary Switch that reducing energy consumption, enhancing the value of technology of your home, condominiums and apartment. The ZW500DM Smart Meter Dimmer Switch enables you to measure the energy usage of your appliance. When added to a Z-Wave network, the ZW500DM reports real time data to your gateway or controller. It can also display actual consumption (in W) and the accumulated power used (in kWh) in the user interface of the gateway/remote. Please use the gateway installation manual for specific instructions on measuring the power.
Security
As a Z-Wave Plus certified product, In-wall Smart Meter Dimmer Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Enerwave Green Automation describes In-wall Smart Meter Dimmer Switch as having the following features:
- Supported Meter Type
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
When the primary controller is in the adding mode, flicks the paddle 3 times in the
1.5 second. The primary controller will verify the adding, assign a node ID number
for the module .
When the primary controller is in the removing mode, flicks the paddle 3 times in
the 1.5 second. The primary controller will verify the removing, remove the module
from the current Z-Wave network, and the LED will blink when the module is on
power
Factory reset In-wall Smart Meter Dimmer Switch
Flicks the program button 3 times in the 1.5 second then press once and hold for
2 second.the device will send a device reset locally notification to controller. Then
clear all of information for the network, and restore factory defaults, and reset the
module. Use this procedure only in the event that the network primary
controller is missing or otherwise inoperable.
Please note that this is a user manual In-wall Smart Meter Dimmer Switch from Enerwave Green Automation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-wall Smart Meter Dimmer Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.