Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-wall Smart Meter ON/OFF Switch (ZW15SM) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-wall Smart Meter ON/OFF Switch (ZW15SM)from Enerwave Green Automation. To view other Z-Wave products and manuals from Enerwave Green Automation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-wall Smart Meter ON/OFF Switch
SKU Code
ZW15SM
Description
The ZW15SM ON/OFF Switch is a perfect wireless manual and remote on/off control replacement of a regular wall switch, controlling incandescent, LED, ballast loads and more. This ZW15SM ON/OFF switch is fully compatible with other Z-Wave certified devices from other manufacturers and/or other applications providers and can be added to any Z-Wave network. As part of any Z-Wave network, each device can be remotely controlled by commands sent from Z-Wave controllers in real time, but each Z-Wave powered device also acts as wireless repeater transmitting RF signals from one to another, thus extending the range of RF signal all over the system. The ZW15SM Smart Meter Switch enables you to measure the energy usage of your appliance. The ZW15SM reports real time data to your gateway or controller. It can also display actual consumption (in W) and the accumulated power used (in kWh) in the user interface of the gateway. Please use the gateway installation manual for specific instructions on measuring the power.
Version #
HW: 1 FW: 5.10 was the version certified
Certification #
ZC10-16075131
Certified
2016-07-01T09:21:48.3124
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, In-wall Smart Meter ON/OFF Switch supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Enerwave Green Automation describes In-wall Smart Meter ON/OFF Switch as having the following features:

    • Electric Load Type
    • Switch Load Capacity Current
    • Switch Load Capacity Volt-Ampere
    • Switch Load Capacity Watts
    • Supported Meter Type
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    When the primary controller is in the adding mode, press the paddle once and hold for 4 seconds. The primary controller will verify the adding, assign a node ID number for the module .

    When the primary controller is in the removing mode, press the paddle once and hold for 4 seconds. The primary controller will verify the removing, remove the module from the current Z-Wave network, and the LED will blink when the module is on power.

    Factory reset In-wall Smart Meter ON/OFF Switch

    Press once and hold for 10 seconds, the device will send a device reset locally notification to controller. Then clear all of information for the network, and restore factory defaults, and reset the module. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual In-wall Smart Meter ON/OFF Switch from Enerwave Green Automation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-wall Smart Meter ON/OFF Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.