Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

IN-Wall Smart Meter TR Duplex Receptacle (ZW15RM) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product IN-Wall Smart Meter TR Duplex Receptacle (ZW15RM)from Enerwave Green Automation. To view other Z-Wave products and manuals from Enerwave Green Automation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
IN-Wall Smart Meter TR Duplex Receptacle
SKU Code
ZW15RM
Description
The ZW15RM TR Duplex Receptacle is a perfect wireless manual and remote on/off control replacement of regular receptacles, controlling table and floor lamps, small appliances, etc. It provides two different type outlets. One outlet with Z-Wave mark has programmable functions such as scenes, association, schedule event, etc. It is fully interoperable with other Z-Wave certified device from other manufacturers and/or other applications. It can report wattage energy usage or kWh energy usage to a Z-Wave gateway.It has a Blue LED on the face cover indicates the status of the controlled outlet and/or act as a night light. The other outlet with Tamper-Resistant feature provides constant power, helps you and your families prevent electrical injuries.
Version #
HW: 1 FW: 5.10 was the version certified
Certification #
ZC10-16055066
Certified
2016-05-10T10:36:32.2694
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, IN-Wall Smart Meter TR Duplex Receptacle supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Enerwave Green Automation describes IN-Wall Smart Meter TR Duplex Receptacle as having the following features:

    • Supported Meter Type
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    When the controller is in add mode and the blue LED is blinking on the
    ZW15RM, press and hold the program button of ZW15RM for 3 second, and
    then the controller will verify the add.

    When the controller is in remove mode, press and hold the program button of
    ZW15RM for 3 second, and then the controller will remove it from the current
    Z-Wave network, and the LED will blink on the receptacle,when power on.

    Factory reset IN-Wall Smart Meter TR Duplex Receptacle

    Once program button is pressed and hold for 10 second, the device will send a device reset locally notification to controller. Then clear all of information for
    the network, and restore factory defaults, and reset the module. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual IN-Wall Smart Meter TR Duplex Receptacle from Enerwave Green Automation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have IN-Wall Smart Meter TR Duplex Receptacle and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.