Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Plug-in Smart Meter Dimmer Module (ZWN-323M) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Plug-in Smart Meter Dimmer Module (ZWN-323M)from Enerwave Green Automation. To view other Z-Wave products and manuals from Enerwave Green Automation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Plug-in Smart Meter Dimmer Module
SKU Code
ZWN-323M
Description
This ZWN-323 Dimming Module is a Z-Wave enabled device and is fully interoperable with other Z-Wave certified device. In a Z-Wave network, ZWN-323M enable you to remotely ON/OFF&Dim control a Z-Wave controlled outlet for the lamp and always-on AC outlet for other device. ZWN-323M also acts as a repeater, retransmitting the RF signal from one device to another until the intended device is reached. With a horizontal design, the ZWN-323M plug-in dimmer module will not block other nearby AC outlets. The ZWN-323M Smart Meter Module enables you to measure the energy usage of your appliance. When added to a Z-Wave network, the Smart Meter Module reports real time data to your gateway or controller. It can also display actual consumption (in W) and the accumulated power used (in kWh) in the user interface of the gateway/remote. Please use the gateway installation manual for specific instructions on measuring the module.
Version #
HW: 1 FW: 5.10 was the version certified
Certification #
ZC10-16065120
Certified
2016-06-27T09:26:00.848
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, Plug-in Smart Meter Dimmer Module supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Enerwave Green Automation describes Plug-in Smart Meter Dimmer Module as having the following features:

    • Supported Meter Type
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    While the gateway/remote is in the adding mode and the blue LED blinks on
    the ZWN-323M, flicks the program button 3 times in the 1.5 second. The gateway
    or remote will verify the adding, assign a node ID number for the module .

    While the gateway or remote in the removing mode, flicks the program button
    3 times in the 1.5 second. The gateway or remote will verify the deleting,
    remove the module from the current Z-Wave network, and the LED will blink
    when the module is on power.

    Factory reset Plug-in Smart Meter Dimmer Module

    Flicks the program button 3 times in the 1.5 second then press once and
    hold for 2 second.the device will send a device reset locally notification to controller. Then clear all of information for the network, and restore factory defaults, and reset the module. Use this procedure only in the event that
    the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual Plug-in Smart Meter Dimmer Module from Enerwave Green Automation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Smart Meter Dimmer Module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.