Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smart Dual Relay Switch Module (ZWN-RSM2) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Dual Relay Switch Module (ZWN-RSM2)from Enerwave Green Automation. To view other Z-Wave products and manuals from Enerwave Green Automation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Dual Relay Switch Module
SKU Code
ZWN-RSM2
Description
The ZWN-RSM2 Switch Module have two channels switch ,that is a component of lighting control system, it can not be used separately but should turn an existing switch into a Z-Wave switch. This ZWN-RSM2 module is a Z-Wave enabled device and is fully compatible with other Z-Wave certified device from other manufacturers. In a Z-Wave network, each device is designed to act as a wireless repeater. Once the ZWN-RSM2 module is installed and setup with in your wall, it will retransmit the RF signal from one device to another until the intended device to intended device is reached. This ensures that the signal is received by its intended destination
Version #
HW: 1 FW: 5.11 was the version certified
Certification #
ZC10-17035461
Certified
2017-03-06T20:57:18.791574
Z-Wave Version
6.51.09

Security

As a Z-Wave Plus certified product, Smart Dual Relay Switch Module supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Enerwave Green Automation describes Smart Dual Relay Switch Module as having the following features:

    • Switch Load Capacity Current
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    When the controller is in add mode,Press and release the program button of ZWN-RSM2 module,or Flick 3 times of the connected switch with Aux1 line(or Aux 2 line) in 1.5 second. Then the controller will add the module into current Z-Wave network.

    When the controller is in remove mode,Press and release the program button of ZWN-RSM2 module, or Flick 3 times of the connected switch with Aux1 line (or Aux2 line) in 1.5 second. Then the controller will remove the module from current Z-Wave network.

    Factory reset Smart Dual Relay Switch Module

    Once program button is pressed and hold for 10 second, the device will send a device reset locally notification to controller. Then clear all of information for the network, and restore factory defaults, and reset the module. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual Smart Dual Relay Switch Module from Enerwave Green Automation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Dual Relay Switch Module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.