Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smart Single Relay Switch Module (ZWN-RSM1) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Single Relay Switch Module (ZWN-RSM1)from Enerwave Green Automation. To view other Z-Wave products and manuals from Enerwave Green Automation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Single Relay Switch Module
SKU Code
ZWN-RSM1
Description
Z-Wave unifies all your home electronics into an integrated wireless network and helps them talk to each other. It can be added to the network,and making your home electronics fully compatible. The ZWN-RSM1 Switch Module is a component of lighting control system, it can’t be used separately but should turn an existing switch into a Z-Wave switch. This ZWN-RSM1 module is a Z-Wave enabled device and fully interoperable with other Z-Wave certified device from other manufacturers and/or other applications. In a Z-Wave network, each device is designed to act as a wireless repeater. Once the ZWN-RSM1 module is installed and setup with in your wall, it will retransmit the RF signal from one device to another until the intended device is reached. This ensures that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots.
Version #
HW: 1 FW: 5.10 was the version certified
Certification #
ZC10-16055064
Certified
2016-05-09T11:12:51.4106
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, Smart Single Relay Switch Module supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Enerwave Green Automation describes Smart Single Relay Switch Module as having the following features:

    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    When the controller is in remove mode, and once program button is pressed and released, or Flick 3 times of the connected switch in 1.5S, will also set the ZWN-RSM1 module enter into learn mode and then the controller will verify the remove.

    When the controller is in add mode, and once program button is pressed and released, or Flick 3 times of the connected switch in 1.5S, will also set the ZWN-RSM1 module enter into learn mode and then the controller will verify the add.

    Factory reset Smart Single Relay Switch Module

    Once program button is pressed and hold for 10 second, the device will send a device reset locally notification to controller. Then clear all of information for the network, and restore factory defaults, and reset the module. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual Smart Single Relay Switch Module from Enerwave Green Automation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Single Relay Switch Module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.