The following is an overview of the user manual for the Z-Wave product SmartHome IoT Hub (EIH-100E)from Enplug Smart IoT. To view other Z-Wave products and manuals from Enplug Smart IoT follow that link.
Overview
Security
As a Z-Wave Plus certified product, SmartHome IoT Hub supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Enplug Smart IoT describes SmartHome IoT Hub as having the following features:
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
- This performs the Z-Wave Set Learn Mode network operation. This can only be performed when Z-Ware is not in a network and will typically make Z-Ware an Inclusion or Secondary Controller, in which case, some of its facilities will not be available. To complete an S2 inclusion, the DSK may need to be entered on the including Controller.
Factory reset SmartHome IoT Hub
- This is the Z-Wave Set Default network operation and a confirmation message appears.
- If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
- Pressing the “ADD NEW DEVICE” button in webpage will let EIH-100E into inclusion mode.
- If the slave is Z-Wave Security 2 device, you need to accept or modify the security class settings. (recommend : the user not change the security class settings.)
- If the slave is Z-Wave Security 2 device for Security 2 Class 1 and 2 devices, you need to key in the first 5 digits of the DSK.
- Pressing the “REMOVE DEVICE” button in webpage will let EIH-100E into exclusion mode.
Please note that this is a user manual SmartHome IoT Hub from Enplug Smart IoT is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have SmartHome IoT Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.