Spirit Z-Wave Plus RU (4260012711110) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Spirit Z-Wave Plus RU (4260012711110)from EUROtronic Technology GmbH. To view other Z-Wave products and manuals from EUROtronic Technology follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Spirit Z-Wave Plus RU
SKU Code
• Easy control for water radiators from any Z-Wave Controller
• Fits most European water radiators (wide range of additional adaptors for different manufacturers available)
• FLiRS for quick response time
• LED Backlit LCD
• Metal nut for reliable connection to the radiator
• 2 buttons for easy temperature regulation
• Battery level indicator
• Child Lock
• Over the Air update
• UK-Mode for upside down installation
• Open Window detection
• Automatic frost protection
Version #
HW: 49 FW: 0.16:00.10 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Spirit Z-Wave Plus RU supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated


EUROtronic Technology describes Spirit Z-Wave Plus RU as having the following features:

  • Firmware updatable via a compatible Z-Wave gateway
  • Battery powered using batteries
  • Supported Notification Types
  • Thermostat HVAC Systems Supported
  • Battery Quantity
  • Thermostat Modes
  • Sensors
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Start Inclusion mode of your primary Z-Wave Controller.
Press the Boost-Button.

Start Exclusion mode of your primary Z-Wave Controller.
Now press and hold the boost button of the Spirit Z-Wave Plus for at least 5 seconds.

Factory reset Spirit Z-Wave Plus RU

Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Remove batteries.
Press and hold boost button.
While still holding boost button insert batteries.
The LCD shows RES. Release boost button.
To perform the factory reset press boost button.

You can wake up the product so that mailboxed commands are sent to it by pressing the boost button.

Please note that this is a user manual Spirit Z-Wave Plus RU from EUROtronic Technology GmbH is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Spirit Z-Wave Plus RU and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.