Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-wall Smart Dimmer (ZW31) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-wall Smart Dimmer (ZW31)from EVA LOGIK. To view other Z-Wave products and manuals from Eva Logik follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-wall Smart Dimmer
SKU Code
ZW31
Description
It is an In-wall type device controlled by Z-Wave controller and can be configured in Z-Wave sensor network, if Z-Wave certified controller features remote access, you can dim lights at home from your mobile phone separately, and manual dim light by push button .
Version #
HW: 1 FW: 20.15 was the version certified
Certification #
ZC10-17045548
Certified
2017-04-17T20:40:31.798188
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, In-wall Smart Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Eva Logik describes In-wall Smart Dimmer as having the following features:

    • Outdoor Use
    • Switch Type
    • Color
    • Electric Load Type
    • Firmware updatable via a compatible Z-Wave gateway
    • IP (Ingress Protection) Rated
    • Switch Load Capacity Watts
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset In-wall Smart Dimmer

    1. Press and hold the top button for at least 3 seconds while you apply AC power to this device.
    2. Use this procedure only in the event that the network primary controller is missing
    or otherwise inoperable.

    1. Follow the instructions for your Z-Wave certified controller to include a device to
    the Z-Wave network.
    2. Once the controller is ready to include your device, press up and release the toggle
    to include it in the network.
    3. Once your controller has confirmed that the device has been included, refresh the
    Z-Wave network to optimize performance.
    4. The device is associated in the same group when it included in setting process.
    Now you can control your Z-Wave device according to groups, scenes, schedules
    and automation programmed.

    1. Follow the instructions for your Z-Wave certified controller to exclude a device
    from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, press up and release the front button to exclude it from the network.

    Please note that this is a user manual In-wall Smart Dimmer from EVA LOGIK is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-wall Smart Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.