Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Outdoor Smart Plug - 2 channel (ZW97) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Outdoor Smart Plug - 2 channel (ZW97)from EVA LOGIK. To view other Z-Wave products and manuals from Eva Logik follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Outdoor Smart Plug - 2 channel
SKU Code
ZW97
Description
The ZW97 is a Z-Wave enabled device and is fully compatible with any Z-Wave Plus enabled network.Each module is designed to act as a repeater,which will re-transmit a radio frequency (RF) signal by routing the signal .around obstacles and radio dead spots to ensure that the signal is received at its intended destination.ZW97 is a security enabled Z-Wave plus device. A security Enabled Z-Wave Plus Controller must be used in order to fully utilize the product.
Version #
HW: 255 FW: 1.01 was the version certified
Certification #
ZC10-19116795
Certified
2019-11-14T10:21:09.470831
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, Outdoor Smart Plug - 2 channel supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Eva Logik describes Outdoor Smart Plug - 2 channel as having the following features:

  • Color
  • Electric Load Type
  • Firmware updatable via a compatible Z-Wave gateway
  • Outdoor Use
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

ADD or Remove the ZW97 from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the PROG button five times in one second.

ADD or Remove the ZW97 from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the PROG button five times in one second.

Factory reset Outdoor Smart Plug - 2 channel

MANUAL RESET
---Power off ZW97
---keep holding the PROG button
---Power on,Press and keep holding the PROG button for no less than 10 seconds.
"Please use this procedure only when the network primary controller is missing or otherwise inoperable."

Please note that this is a user manual Outdoor Smart Plug - 2 channel from EVA LOGIK is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Outdoor Smart Plug - 2 channel and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.