Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

S2 In-wall Smart Dimmer switch (ZW31) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product S2 In-wall Smart Dimmer switch (ZW31)from EVA LOGIK. To view other Z-Wave products and manuals from Eva Logik follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
S2 In-wall Smart Dimmer switch
SKU Code
ZW31
Description
This product can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.Each module is designed to act as a repeater,which will re-transmit a radio frequency (RF) signal by routing the signal ,around obstacles and radio dead spots to ensure that the signal is received at its intended destination.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
ZC10-19086704
Certified
2019-08-05T21:08:30.516704
Z-Wave Version
6.81.03

Security

As a Z-Wave Plus certified product, S2 In-wall Smart Dimmer switch supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Eva Logik describes S2 In-wall Smart Dimmer switch as having the following features:

  • Color
  • Electric Load Type
  • Firmware updatable via a compatible Z-Wave gateway
  • Switch Load Capacity Watts
  • Switch Type
  • Z-Wave Scene Type
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
2. Once the controller is ready to include your device, press up and release the toggle three times to include it in the network.
3. Once your controller has confirmed that the device has been included, refresh the Z-Wave network to optimize performance.
4. The device is associated in the same group when it included in setting process.

1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, press up and release the front button Three times to exclude it from the network.

Factory reset S2 In-wall Smart Dimmer switch

Press click Z-Wave button3 times quickly,and hold the third time for at least 10 seconds. to restore the device to the factory.Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Please note that this is a user manual S2 In-wall Smart Dimmer switch from EVA LOGIK is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S2 In-wall Smart Dimmer switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.