The following is an overview of the user manual for the Z-Wave product Smart Plug switch (ZW36)from EVA LOGIK. To view other Z-Wave products and manuals from Eva Logik follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Plug switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Eva Logik describes Smart Plug switch as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Neutral Wire Required
- Switch Load Capacity Watts
- Switch Type
- Switch Load Capacity Current
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Smart Plug switch
1. Press and hold the top button for at least 3 seconds while you plug the smart switch into a receptacle.
2. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
2. Once the controller is ready to include your device, press up and release the toggle to include it in the network.
3. Once your controller has confirmed that the device has been included, refresh the
Z-Wave network to optimize performance.
4. The device is associated in the same group when it included in setting process.
Now you can control your Z-Wave device according to groups, scenes, schedules and automation programmed.
1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, press up and
release the front button to exclude it from the network.
Please note that this is a user manual Smart Plug switch from EVA LOGIK is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.