Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Z-Wave Plus Power Strip (ZW1505) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Power Strip (ZW1505)from EVA LOGIK. To view other Z-Wave products and manuals from Eva Logik follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Wave Plus Power Strip
SKU Code
ZW1505
Description
It is power strip type device controlled by Z-Wave controller and can be configured in Z-Wave sensor network, if Z-Wave certified controller features remote access, you can dim lights at home from your mobile phone separately, and manual dim light by push button .
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
ZC10-18116299
Certified
2018-11-01T19:40:40.113937
Z-Wave Version
6.71.03

Security

As a Z-Wave Plus certified product, Z-Wave Plus Power Strip supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Eva Logik describes Z-Wave Plus Power Strip as having the following features:

  • Switch Load Capacity Current
  • Switch Load Capacity Watts
  • Color
  • Electric Load Type
  • Firmware updatable via a compatible Z-Wave gateway
  • Supported Meter Type
  • Supported Notification Types
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Inclusion the ZW1505 from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the PROG button Three times in one second.

Inclusion the ZW1505 from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, click the PROG button Three times in one second.

Factory reset Z-Wave Plus Power Strip

Press the button twice quickly and then press and hold the button 10S.device will reset
Please use this procedure only when the network primary controller is missing or otherwise inoperable

Please note that this is a user manual Z-Wave Plus Power Strip from EVA LOGIK is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Power Strip and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.