The following is an overview of the user manual for the Z-Wave product S2 Smart Start On/Off Switch (ZW30S)from Evaloigk. To view other Z-Wave products and manuals from Evaloigk follow that link.
Overview
Security
As a Z-Wave Plus certified product, S2 Smart Start On/Off Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Evaloigk describes S2 Smart Start On/Off Switch as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Type
- Z-Wave Scene Type
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1,Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2,When prompted by your primary controller, click the Up or Down button three times in one second.
1,Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2,When prompted by your primary controller, click the Up or Down button three times in one second.
Factory reset S2 Smart Start On/Off Switch
Press and hold lower paddle for 10 seconds,then LED starts blinking, release paddle and within 2 seconds,click lower paddle 5 times
(Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable.)
SmartStart location
SmartStart QR code's location as follows: The device support two methods of inclusion,When using a Z-Wave Plus certified controller choose Network Wide Inclusion or SmartStart,
Network Wide Inclusion To A Z-Wave Network
1,Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
2,When prompted by your primary controller, click the Up or Down button three times in one second.
The device is compatible with SmartStart
SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code found on the top of the outlet or the back of
the box with a controller providing SmartStart inclusion.No further action is required and the SmartStart product will be added automatically within
10 minutes of being switched on and in the network vicinity.
QR CODE
the QR code are sticked to the side of the case,DSK is included in the QR code.
DSK
The DSK code can be found on the DSK label which is attached on the packaging box.
Please note that this is a user manual S2 Smart Start On/Off Switch from Evaloigk is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S2 Smart Start On/Off Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.