Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall On/Off Switch Module (AN179-0) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall On/Off Switch Module (AN179-0)from Everspring. To view other Z-Wave products and manuals from Everspring follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall On/Off Switch Module
SKU Code
AN179-0
Description
The In-Wall On/Off Module is a Z-Wave enabled device which is fully compatible with any Z-Wave enabled network. Z-Wave enabled devices displaying the Z-Wave logo can also be used with it regardless of the manufacturer, and ours can also be used in other manufacturer’s Z-Wave enabled networks. Inclusion of this unit on other manufacturer’s Wireless Controller menu allows remote operation of the unit and the connected load. Z-Wave node in the system also acts as a repeater, so the RF signal can reach its intended receiver by routing around obstacles and radio dead spots.

The In-Wall On/Off Module is designed to control the on/off status of lighting and appliances load in your house. Two sets of dry contacts provide more wiring applications. For security, the unit can detect overheating and will turn off relay automatically to avoid damage. At 230V voltage, this module can support up to 2500W resistive, 1200W incandescent, 700W motor, or 320W (40W*8) fluorescent load.
Version #
02 was the version certified
Certification #
ZC10-14080013
Certified
2014-07-11T16:04:49.868624
Z-Wave Version
6.51.02

Security

As a Z-Wave Plus certified product, In-Wall On/Off Switch Module supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Everspring describes In-Wall On/Off Switch Module as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Put the Z-Wave Controller into inclusion mode.
    2. Press the link key three times within 1.5 seconds to put the unit into inclusion mode.

    1. Put the Z-Wave Controller into exclusion mode.
    2. Press the link key three times within 1.5 seconds to put the unit into exclusion mode.

    NR

    NR

    NR

    Factory reset In-Wall On/Off Switch Module

    (This procedure should only be used when the primary controller is no longer operational.)
    1. Press the link key three times within 1.5 seconds to put the unit into exclusion mode.
    2. Within 1 second of step 1, press link key again and hold until LED is off (about 5 sec.).
    3. Node ID is excluded, and the unit is returned to the factory default state.

    Please note that this is a user manual In-Wall On/Off Switch Module from Everspring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall On/Off Switch Module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.