The following is an overview of the user manual for the Z-Wave product On/off Plug (AN186-1)from Everspring. To view other Z-Wave products and manuals from Everspring follow that link.
Overview
This On/Off Plug module is designed to control the on/off status of lighting and appliances in the home. Remote On/Off control of the connected load is possible even when paired with other manufacturer’s Wireless Controller. Each module is also designed to act as a repeater to re-transmit RF signal to ensure that it is received by its intended destination by routing the signal around obstacles and radio dead spots.
Security
As a Z-Wave Plus certified product, On/off Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Everspring describes On/off Plug as having the following features:
- Color
- Switch Load Capacity Watts
- Supported Notification Types
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Communications Connections
- Electric Load Type
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put the Z-Wave Controller into Inclusion mode.
2. Press the On/Off knob 3 times within 1.5 seconds to put the unit into Inclusion mode.
1. Put the Z-Wave Controller into Exclusion mode.
2. Press the On/Off knob 3 times within 1.5 seconds to put the unit into Exclusion mode.
Factory reset On/off Plug
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Press the On/Off knob 3 times within 1.5 seconds to put the unit into exclusion mode.
2. Within 1 second of step 1, press and hold the knob for 5 seconds.
3. Node ID is deleted. The device reverts to factory default state.
Please note that this is a user manual On/off Plug from Everspring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have On/off Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.