The following is an overview of the user manual for the Z-Wave product EZMultiPli (EZMultiPli)from Express Controls LLC. To view other Z-Wave products and manuals from Express Controls follow that link.
Overview
Notify caregivers when a loved one does not get up at their usual time or gets up multiple times during the night. Easily installed in a kitchen, bathroom, bedroom or hallway - just plug it in! The wide angle motion sensor detects motion when placed at floor level in a normal wall outlet or at counter height in a kitchen or bath. Never needs batteries!
Receive an email or text when motion is detected or the temperature is dangerously low while you are away. Turn on lights and sirens automatically.
Save energy by automatically turning off lights in unoccupied rooms or hallways.
Set the color LED night light to inform you that your garage door is open, there is a severe weather alert or any indicator you can imagine!
Operates as a Z-Wave range extender utilizing fifth generation Z-Wave technology to enhance the reliability and speed of every device on a Z-Wave network
Security
As a Z-Wave Plus certified product, EZMultiPli supports Z-Wave S2 security. The following security modes are directly supported:
Features
Express Controls describes EZMultiPli as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
When EZMultiPli has not yet been joined to a Z-Wave network, the LED blinks aqua.
To Include: Put the controller into learn mode, then press and release the push button on the side of EZMultiPli. The LED will blink blue while EZMultiPli is trying to join the Z-Wave network. Once joined to the network, EZMultiPli enters a motion sensor test mode and the LED will blink white each time motion is detected. This mode lasts for about 5 minutes and then the LED will go out.
If EZMultiPli is unable to join the network, it will return to blinking aqua.
Factory reset EZMultiPli
Excluding from a Z-Wave network will return the device to factory defaults. See the Product Exclusion Description for details.
There are two methods for exclusion:
1) Put the controller into exclusion mode, then press and release the push button on the side of EZMultiPli. The LED will blink aqua when no longer joined to the network.
2) Press and hold the push button. The LED will blink blue faster and faster and then shift to yellow and continue to blink faster and faster. Once the LED goes out, EZMultiPli is reset to the factory defaults and will blink aqua.
Method 1 is recommended. Method 2 should only to be used in the event that the primary controller is missing or otherwise inoperable.
Please note that this is a user manual EZMultiPli from Express Controls LLC is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have EZMultiPli and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.