EZZee (EZZeeUS) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product EZZee (EZZeeUS)from Express Controls LLC. To view other Z-Wave products and manuals from Express Controls follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


SKU Code
The EZZee Z-Wave Interface Board provides a simple to use and easy to integrate Z-Wave interface for any embedded computer. Specifically designed for the Raspberry Pi, EZZee uses a UART interface available on most embedded CPUs. The Sigma Designs SerialAPI provides a standard software interface to communicate with any Z-Wave device on the Z-Wave network.
Version #
HW: 13 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, EZZee supports Z-Wave S2 security. The following security modes are directly supported:


    Express Controls describes EZZee as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Use the SerialAPI

    Use the SerialAPI

    RGB LED controlled by pins of the Raspberry Pi connector

    Use the SerialAPI

    Factory reset EZZee

    Use the SerialAPI

    Please note that this is a user manual EZZee from Express Controls LLC is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have EZZee and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.