The following is an overview of the user manual for the Z-Wave product Atom OEM (eZLO Atom-US-OEM)from eZLO. To view other Z-Wave products and manuals from eZLO follow that link.
Overview
With no wires and no hassle for setup, users can simply plug in the Ezlo Atom, pair devices using the application, and start a smart home system with lights, sensors, thermostats, door locks, and more. The Atom works with Amazon’s Alexa and Google Assistant, and is also compatible with Siri Shortcuts. Users can even send commands between these assistants from a single app using the Ezlo VOI feature.
It’s small size, portability, and affordable price make the Atom ideal for renters and apartment dwellers, or for homeowners looking to embrace the benefits of home control for the first time.
Plus, the application features an intuitive interface, powerful scene creation tools, a customizable dashboard, and more to personalize the user experience.
Taken together, these features make Atom an ideal way to introduce home control to a broader audience, and finally deliver on the promise of mass market home automation.
Security
As a Z-Wave Plus certified product, Atom OEM supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
eZLO describes Atom OEM as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
LearnMode is not supported in this version
SmartStart location
SmartStart QR code's location as follows: The QR code version of the DSK may be found on the back of the product as well as on the packaging.
Generic Z-Wave Remove
1. The unit can be taken to exclusion by going to the device which is going to be excluded, then tap on the trash can icon.
2. Select UNPAIR, which will set the controller into exclusion mode, you will see a message at the top of the screen which says: Remove device now…
3. Follow the instructions to exclude the device, after this process, the device will be removed from
the z-wave network and from the UI.
Generic Z-Wave Add
Factory reset Atom OEM
Press and hold Button for More than 10 seconds. LED will start flashing
Wi-Fi Reset
Soft Reset
Generic Z-Wave Add
1. Open the mobile app, and tap on the three-line icon in the top right corner to open the left-hand-side menu, then select Devices.
2. On the device screen, tap on Add Device
3. Look for the device you want to pair, once you find it select it from the list. If your device is in the list, you will get a dedicated Device Pairing wizard, which will walk you through the procedure step by step.
4. The controller it’s set into inclusion mode and the message: Add new devices now… will appear at the top. The controller sets a 60-second countdown timer, during which it will keep scanning for devices.
5. Follow the inclusion steps to pair the device. Once your device is detected, you'll get a
confirmation pop-up message on the screen, and then you can go on to assign a name and a
room for the device. You can tap on I'm Done Adding Devices to then wrap up the process,
after which point you will see your device in the Devices screen.
Please note that this is a user manual Atom OEM from eZLO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Atom OEM and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.