Electronic Z-Wave Deadbolt (A32-WG014-S2) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Electronic Z-Wave Deadbolt (A32-WG014-S2)from Faultless. To view other Z-Wave products and manuals from FAULTLESS follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Electronic Z-Wave Deadbolt
SKU Code
A32-WG014-S2
Description
Great Convenience
。Connect your Z-Wave smart home system and operate from anywhere
。Holds up to 10 user codes
。Holds up to 4 single-entry codes
。Vacation mode (deactivates all user codes temporarily)
。Auto-lock with adjustable delay (10 - 99 seconds)
。Back-up mechanical keyway
Uncompromised Security
。ANSI Grade 3 quality – deadbolt operates over 100,000 times
。ANSI A156.25 compliant - resistant to dust, rain, and corrosion under variable temperatures
。4-digit random guiding code prevents code-probing
。Touch screen is temporarily disabled after 4 consecutive incorrect entries
Version #
HW: 255 FW: 3.01:01.01 was the version certified
Certification #
ZC10-18116313
Certified
2018-11-20T08:08:03.27126
Z-Wave Version
6.71.03

Security

As a Z-Wave Plus certified product, Electronic Z-Wave Deadbolt supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Access Control

Features

FAULTLESS describes Electronic Z-Wave Deadbolt as having the following features:

  • Supported Notification Types
  • Battery Quantity
  • Door Lock Type
  • Battery powered using AA batteries
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

1.Press [SET] for 1 second.
2.Programming Code(6 digits)
3.Press the buttons lock-button 9 0 lock-button
4.Exclude successfully (beep x 1)

1.Press [SET] for 1 second.
2.Programming Code(6 digits)
3.Press the buttons lock-button 9 0 lock-button
4.Include successfully (beep x 1)

Factory reset Electronic Z-Wave Deadbolt

1. Remove one battery
2. Press and hold SET button while inserting the battery back.
Hold the set button until long beep has finished.
3. Restoring the lock to factory settings will remove its connection to your network and clear all devices from its association group.
The reset procedure should only be used when the primary controller is missing or inoperable.

Please note that this is a user manual Electronic Z-Wave Deadbolt from Faultless is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Electronic Z-Wave Deadbolt and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.