The following is an overview of the user manual for the Z-Wave product TPD Z-Wave (A15-WG014)from Faultless. To view other Z-Wave products and manuals from FAULTLESS follow that link.
Overview
。Touch to activate, touch to lock
。Connect your Z-Wave smart home system and operate from anywhere
。Holds up to 25 user codes
。Holds up to 4 single-entry codes
。Vacation mode (deactivates all user codes temporarily)
。Auto-lock with adjustable delay (10 - 99 seconds)
。Back-up mechanical keyway
Uncompromised Security
。ANSI Grade 2 quality – deadbolt operates over 150,000 times
。ANSI A156.25 compliant - resistant to dust, rain, and corrosion under variable
temperatures
。4-digit random guiding code prevents code-probing
。Touch screen is temporarily disabled after 4 consecutive incorrect entries
Easy Installation
。Easy installation with a Philips screwdriver
。Fits most standard door preparations
。Online video instruction available (please scan the QR code on this box)
Security
As a Z-Wave Plus certified product, TPD Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:
Features
FAULTLESS describes TPD Z-Wave as having the following features:
- Battery powered using AA batteries
- Door Lock Type
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Press [SET] for 1 second
2. Enter 4-8 digits Programing Code
3. Press the buttons #90#
4. Include successfully (beep * 1)
1. Press [SET] for 1 second
2. Enter 4-8 digits Programing Code
3. Press the buttons #90#
4. Exclude successfully (beep * 1)
Factory reset TPD Z-Wave
1. Remove one battery.
2. Press and hold SET button while inserting the battery back. Hold the set button until long beep has finished.
3. Resotring the lock to factory settings will remove its connection to your network and clear all devices from its assocation group. The reset procedure should only be used when the primary controller is missing or inoperable.
4. Please re-enter the default Programming Code to set up the lock after restoring to factory settings.
Please note that this is a user manual TPD Z-Wave from Faultless is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have TPD Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.