The following is an overview of the user manual for the Z-Wave product Button (FGPB-101)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Different actions may be triggered with one to five clicks or by holding the button down. In Panic Button mode, each press of the button results in triggering the Fibaro Alarm.
With its small design and wireless communication, the FIBARO Button can be conveniently mounted on any surface and in any position or location at home, e.g. beside the bed or under the desk.
Security
As a Z-Wave Plus certified product, Button supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes Button as having the following features:
- Battery powered using ER14250 (½AA) batteries
- Battery Quantity
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
The Button needs to be woken up to receive information about the new configuration from the controller, like parameters and associations.
1) Click the Button 4 times to wake it up.
1) Place the Button within the direct range of your Z-Wave controller.
2) Set the main controller in (security/non-security) add mode (see the controller’s manual).
3) Click the Button at least six times.
4) Wait for the adding process to end.
5) Successful adding will be confirmed by the Z-Wave controller’s message.
1) Place the Button within the direct range of your Z-Wave controller.
2) Set the main controller in remove mode (see the controller’s manual).
3) Click the Button at least six times.
4) Wait for the removing process to end.
5) Successful removing will be confirmed by the Z-Wave controller’s message.
Factory reset Button
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. In order to reset the device:
1) Click the Button exactly five times.
2) Press and hold the Button for at least 5 seconds.
Resetting the device is not the recommended way of removing the device from the Z-Wave network. Use reset procedure only if the primary controller is missing or inoperable. Certain device removal can be achieved by the procedure of removing.
Please note that this is a user manual Button from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Button and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.