The following is an overview of the user manual for the Z-Wave product CO Sensor (FGCD-001)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Security
As a Z-Wave Plus certified product, CO Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes CO Sensor as having the following features:
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Place the device within direct range of the Z-Wave controller.
2) Set the main Z-Wave controller in (security/non-security) adding mode (see the controller’s manual).
3) Quickly, triple click the button located on the casing.
4) Wait for the device to be added into the system.
5) Successful adding will be confirmed by the Z-Wave controller’s message.
1) Place the device within direct range of the Z-Wave controller.
2) Set the main Z-Wave controller in remove mode (see the controller’s manual).
3) Quickly, triple click the button located on the casing.
4) Wait for the removing process to end.
5) Successful removing will be confirmed by the Z-Wave controller’s message.
Factory reset CO Sensor
1) Press and hold the button.
2) Release the button when LED indicator glows white.
3) Click the button when LED indicator glows yellow.
4) After few seconds the device will be reset (confirmed by red LED indicator).
Resetting the device is not the recommended way of removing the device from the Z-Wave network. use the reset procedure only if the primary controller is missing or inoperable.
The CO Sensor needs to be woken up to receive information about the new configuration from the Z-Wave controller, like parameters and associations. To wake up the sensor manually click the button located on the casing.
Please note that this is a user manual CO Sensor from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have CO Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.