The following is an overview of the user manual for the Z-Wave product Door/Window Sensor 2 (FGDW-002)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Sensor can be used to trigger scenes and wherever there is a need for information about opening or closing of doors, windows, garage doors, etc. Opening is detected by separating the sensor’s body and the magnet.
Security
As a Z-Wave Plus certified product, Door/Window Sensor 2 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes Door/Window Sensor 2 as having the following features:
- Sensors
- Firmware updatable via a compatible Z-Wave gateway
- Battery Quantity
- Supported Notification Types
- Battery powered using ER14250 (½AA) batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
The Door/Window Sensor 2 needs to be woken up to receive informa¬tion about the new configuration from the controller, like parameters and associations.
1) To wake up the sensor manually, click one of the TMP buttons (while the other button is pressed).
1) Place the Door/Window Sensor 2 within the direct range of your Z-Wave controller.
2) Set the main controller in (security/non-security) add mode (see the controller’s manual).
3) Click the Button at least six times.
4) Quickly, three times press one of the TMP buttons (while the other button is pressed).
5) Wait for the adding process to end.
6) Successful adding will be confirmed by the Z-Wave controller’s message.
1) Place the Door/Window Sensor 2 within the direct range of your Z-Wave controller.
2) Set the main controller into remove mode (see the controller’s manual).
3) Quickly, three times press one of the TMP buttons (while the other button is pressed).
4) Wait for the removing process to end.
5) Successful removing will be confirmed by the Z-Wave controller’s message.
Factory reset Door/Window Sensor 2
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. In order to reset the device:
1) Open the cover.
2) Remove the battery.
3) Install the battery while holding both TMP buttons.
4) Release the TMP button within 5 seconds.
5) Visual indicator will blink 3 times to confirm launching of reset procedure.
6) Wait around 30s for the resetting process to end, do not remove the battery.
7) Visual LED indicator will blink 6 times to confirm the reset.
*Resetting the device is not the recommended way of removing the device from the Z-Wave network. Use reset procedure only if the primary controller is missing or inoperable.
Please note that this is a user manual Door/Window Sensor 2 from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor 2 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.