The following is an overview of the user manual for the Z-Wave product Door/Window Sensor (FGK-10X)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Sensor can be used to trigger scenes and everywhere there is a need for information about opening or closing of doors, windows, garage doors, etc. Opening is detected by separating the sensor’s body and the magnet.
In addition the FIBARO Door/Window Sensor supports one DS18B20 temperature sensor and has one potential free input.
The FIBARO Door / Window Sensor is available in seven colors: white, silver, black, pearl powder, cappuccino, truffle surprise and dark chocolate.
https://www.youtube.com/watch?v=K35uFXoa5c0
Security
As a Z-Wave Plus certified product, Door/Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes Door/Window Sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Place the device within direct reange of the Z-Wave controller.
2) Make sure that Sensor's cover is closed.
3) Set the main Z-Wave controller into learning mode (see main controller’s operating manual).
4) Quickly, triple click the TMP button.
5) Wait for the device to be excluded from the system. Successful exclusion will be confirmed by the controller.
1) Open the cover.
2) Remove the battery blocker.
3) Close the cover.
4) Locate the sensor nearby the main Z-Wave controller.
5) Set the main Z-Wave controller into adding mode (see main controller’s operating manual).
6) Quickly, triple click the TMP button located on the bottom of the casing.
7) Wait for the device to be added to the system.
8) Successful adding will be confirmed by the controller.
9) Install the device using the attached self-adhesive pads.
FIBARO Door/Window Sensor will wake up at a defined time interval and will ALWAYS try to communicate with the main controller. Setting wake up interval to 0 disables sending Wake Up Notification frame automatically. There is a possibility to wake up the device manually by a single TMP button click.
Factory reset Door/Window Sensor
Resetting the device is not the recommended way of removing the device from the Z-Wave network. Use reset procedure only if the primary controller is missing or inoperable.
1) Take off the Sensor's cover and remove battery.
2) Install the battery while holding both TMP buttons (after mounting the device, one button is constantly pressed by the cover).
3) Release the TMP button within 5 seconds.
4) LED will blink 3 times to confirm launching of reset procedure.
5) Reset procedure may last up to 30 seconds. Do not remove the battery until reset is complete.
6) Reset will be confirmed by the six blinks of the LED.
Please note that this is a user manual Door/Window Sensor from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.