The following is an overview of the user manual for the Z-Wave product Fgs-224 (FGS-224)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Module is designed to turn electrical devices or circuits on and off.
Double Smart Module allows to control two devices or circuits.
The compact size of the device allows for the product to be installed
in the housings of other devices. The devices can be controlled either
via the Z-Wave™ network or with buttons connected directly to them.
Security
As a Z-Wave Plus certified product, Fgs-224 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Fibaro describes Fgs-224 as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add the device to the Z-Wave network manually:
1. Power the device.
2. Set the main controller in (Security/non-Security Mode) add mode
(see the controller’s manual).
3. Quickly, three times click button connected to S1/S2 or the
maintenance button.
4. LED will start blinking yellow, wait for the adding process to end.
5. If you are adding in Security S2 Authenticated, input the underlined
part of the DSK (label on the bottom of the box).
6. Adding result will be confirmed by the Z-Wave controller’s message
and the LED:
• Green – successful (non-secure, S0, S2 non-authenticated),
• Magenta – successful (Security S2 Authenticated),
• Red – not successful.
To remove the device from the Z-Wave network:
1. Power the device.
2. Set the main controller into remove mode (see the controller’s
manual).
3. Quickly, three times click the maintenance button.
4. LED will start blinking yellow, wait for the removing process to
end.
5. Successful removing will be confirmed by the Z-Wave controller’s
message and red LED colour.
Factory reset Fgs-224
1. Press and hold the maintenance button to enter the menu.
2. Release button when the device glows yellow.
3. Quickly click the button to confirm.
4. After few seconds the device will be restarted, which is signalled
with red LED colour.
SmartStart location
SmartStart QR code's location as follows: If you are adding in Security S2 Authenticated, input the underlined
part of the DSK (label on the bottom of the box).
Please note that this is a user manual Fgs-224 from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Fgs-224 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.