The following is an overview of the user manual for the Z-Wave product KeyFob (FGKF-601)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Six buttons allow you to control other devices through the Z-Wave network and run various scenes defined in FIBARO System.
Configure actions for one, two, three clicks and holding the button to suit all your needs.
Built-in locking system will ensure that unauthorized person will not take control of your home.
Security
As a Z-Wave Plus certified product, KeyFob supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes KeyFob as having the following features:
- Battery powered using CR2450 batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
The Keyfob needs to be woken up to receive information about the new configuration from the Z-Wave controller, like parameters and associations. To wake up the device press O and + simultaneously or use 1st menu position:
1) Press O and – simultaneously.
2) Press Δ or X until LED glows white.
3) Press + to confirm.
1) Place the KeyFob within the direct range of your Z-Wave controller.
2) Set the main Z-Wave controller in remove mode (see the controller’s manual).
3) Press O and – simultaneously.
4) Press Δ or X until LED glows green.
5) Press + to confirm.
6) Wait for the removing process to end.
7) Successful removing will be confirmed by the Z-Wave controller’s message.
1) Place the KeyFob within the direct range of your Z-Wave controller.
2) Set the main Z-Wave controller in (security/non-security) add mode (see the controller’s manual).
3) Press any button three times.
4) Wait for the adding process to end.
5) Successful adding will be confirmed by the Z-Wave controller’s message and green LED colour.
Factory reset KeyFob
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. There are two ways of resetting the device:
• Resetting using the menu
1) Press O and – simultaneously.
2) Press Δ or X until LED glows yellow.
3) Press + to confirm.
• Resetting on start-up
1) Remove the battery.
2) Hold O and + while inserting the battery.
Successful resetting will be confirmed by smoothly brightening and dimming of the yellow LED colour.
Please use this procedure only when the network primary controller is missing or otherwise inoperable
Please note that this is a user manual KeyFob from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have KeyFob and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.