Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Motion Sensor (FGMS-001) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Motion Sensor (FGMS-001)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
FIBARO Motion Sensor
SKU Code
FGMS-001
Description
FIBARO Motion Sensor is a universal, Z-Wave Plus compatible multi-sensor. This device has a built-in motion sensor, temperature sensor and light sensor. Additionally, through vibrations detection, it may detect tampering attempt or an earthquake. FIBARO Motion Sensor is battery powered, completely wireless, and its casing allows for quick and non-invasive installation on any surface. The eye of the sensor visually indicates motion, temperature level, operating mode or may inform about Z-Wave network range. The device can be used for lighting scenes and presence monitoring systems.
Version #
HW: 1 FW: 3.03:03.03 was the version certified
Certification #
ZC10-19066573
Certified
2019-06-28T04:38:20.520627
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Fibaro describes Motion Sensor as having the following features:

    • Battery powered using CR123A batteries
    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • Sensors
    • Supported Notification Types
    • Battery Quantity
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Open the cover by turning it counter-clockwise.
    2. Place the device within the direct range of your Z-Wave controller.
    3. Set the main controller in (security/non-security) add mode (see the controller’s manual).
    4. Quickly, three times press the B-button.
    5. Wait for the adding process to end.
    6. Successful adding will be confirmed by the Z-Wave controller’s message.

    1. Open the cover by turning it counter-clockwise.
    2. Place the device within the direct range of your Z-Wave controller.
    3. Set the main controller in remove mode (see the controller’s manual).
    4. Quickly, three times press the B-button.
    5. Wait for the removing process to end.
    6. Successful removing will be confirmed by the Z-Wave controller’s message.

    Factory reset Motion Sensor

    1. Open the cover by turning it counter-clockwise.
    2. Press and hold the B-button.
    3. Wait for visual indicator to glow yellow (2nd menu position).
    4. Release the B-button.
    5. Click the B-button to confirm selection.
    6. After few seconds the device will be reset, which is signalled with the red, fading visual indicator colour.
    Use reset procedure only if the primary controller is missing or inoperable.

    The Motion Sensor will wake up at a defined time interval and will always try to communicate with the main controller. There is a possibility to wake up the device manually by clicking the B-button.

    Please note that this is a user manual Motion Sensor from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.