The following is an overview of the user manual for the Z-Wave product Single Switch 2 (FGS-213)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Security
As a Z-Wave Plus certified product, Single Switch 2 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes Single Switch 2 as having the following features:
- Supported Meter Type
- Supported Notification Types
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Single Switch 2
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. In order to reset the device:
1) Switch off the mains voltage (disable the fuse).
2) Remove the Switch 2 from the wall switch box.
3) Switch on the mains voltage.
4) Press and hold the B-button to enter the menu.
5) Wait for the visual LED indicator to glow yellow.
6) Quickly release and click the B-button again.
7) After few seconds the device will be restarted, which is signalled with the red LED indicator colour.
Use reset procedure only if the primary controller is missing or inoperable.
1) Make sure the Switch 2 is within the direct range of your Z-Wave controller.
2) Identify the S1 switch or the B-button (located on the device’s housing).
3) Set the main controller in remove mode (see the controller’s manual).
4) Quickly, three times press the S1 switch or the B-button.
5) Wait for the removing process to end.
6) Successful removing will be confirmed by the Z-Wave controller’s message
1) Switch off the mains voltage (disable the fuse).
2) Make sure the Switch 2 is within the direct range of your Z-Wave controller.
3) Connect the device in accordance with one of the diagrams included in the manual.
4) After verifying correctness of the connection switch on the mains voltage.
5) Identify the S1 switch or the B-button (located on the device’s housing).
6) Set the main controller in (security/non-security) add mode (see the controller’s manual).
7) Quickly, three times press the S1 switch or the B-button.
8) Wait for the adding process to end.
9) Successful adding will be confirmed by the Z-Wave controller’s message.
The FIBARO Single Switch 2 is powered with the mains voltage so it is always awake.
Z-Wave Plus communication protocol
Active power and energy metering functionality
Z-Wave range tester
LED diode
Please note that this is a user manual Single Switch 2 from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Single Switch 2 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.