The following is an overview of the user manual for the Z-Wave product Swipe (FGGC-001)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Installed device perfectly matches your interior design, as it resembles a picture frame. You can even personalize it with your favourite picture. Gesture controlled menu allow to add/remove or reset the device without dismounting it.
The device is equipped with a buzzer that confirms performed gestures and other actions.
Security
As a Z-Wave Plus certified product, Swipe supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes Swipe as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Place the Swipe within the direct range of your Z-Wave controller.
2) Set the main controller in (security/non-security) add mode (see the controller’s manual).
3) Move and hold your hand close to the centre of the pad.
4) If the device is battery powered, high pitched beep will signal exiting the Standby Mode.
5) Loud sound sequence will confirm entering the menu, keep holding your hand.
6) After hearing two short beeps, withdraw the hand and perform swiping up gesture to confirm selection (two beeps will confirm validity).
7) Wait for the adding process to end.
8) Successful adding will be confirmed by the Z-Wave controller’s message and 3 short beeps.
Factory reset Swipe
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. In order to reset the device:
1) Make sure the device is powered.
2) Move and hold your hand close to the center of the pad.
3) Loud sound sequence will confirm entering the menu, keep holding your hand.
4) Wait for the buzzer to indicate the 3rd menu position (3 short beeps)
5) Withdraw the hand and perform swiping up gesture to confirm selection (two beeps will confirm validity).
1) Place the Swipe within the direct range of your Z-Wave controller.
2) Set the main controller in remove mode (see the controller’s manual).
3) Move and hold your hand close to the centre of the pad.
4) If the device is battery powered, high pitched beep will signal exiting the Standby Mode.
5) Loud sound sequence will confirm entering the menu, keep holding your hand.
6) After hearing two short beeps (green indicator colour), withdraw the hand and perform swiping up gesture to confirm selection (two beeps will confirm validity).
7) Wait for the removing process to end.
8) Successful removing will be confirmed by the Z-Wave controller’s message and sequence of 2 short beeps, pause, 1 short beep.
The Swipe needs to be woken up to receive information about the new configuration from the Z-Wave controller, like parameters and associations. Use 1st menu position to wake up the device or click the button on the back of the device once.
1) Move and hold your hand close to the center of the pad.
2) Loud sound sequence will confirm entering the menu, keep holding your hand.
3) Wait for the buzzer to indicate the 1st menu position (1 short beep)
4) Withdraw the hand and perform swiping up gesture to confirm selection (two beeps will confirm validity).
Please note that this is a user manual Swipe from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Swipe and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.