The following is an overview of the user manual for the Z-Wave product Wall Plug E/F (FGWPE/F-102)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Main features:
• Compatible with any Z-Wave or Z-Wave Plus Controller.
• Supports protected mode (Z-Wave network security mode) with AES-128 encryption.
• Extremely easy installation - simply plug the device into the mains socket.
• Works as a Z-Wave signal repeater.
• Active power and energy consumption metering.
• Current value of the load and operating mode are indicated by the multi-colour LED ring.
Security
As a Z-Wave Plus certified product, Wall Plug E/F supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes Wall Plug E/F as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Plug the device into a socket nearby the main Z-Wave controller.
2) The LED ring will glow red signalling not being added (remove the device otherwise).
3) Set the main Z-Wave controller into adding mode (see the controller’s manual).
4) Quickly, triple click the B-button located on the casing.
5) Wait for the adding process to end.
6) Successful adding will be confirmed by the Z-Wave controller.
1) Plug the device into a socket nearby the main Z-Wave controller.
2) The LED ring will glow green signalling being added (removing is not necessary otherwise).
3) Set the main Z-Wave controller into remove mode (see the controller’s manual).
4) Quickly, triple click the B-button located on the casing.
5) Wait for the removing process to end.
6) Successful removing will be confirmed by the Z-Wave controller.
Wakeup Description
FIBARO Wall Plug is powered with mains voltage so it is always awake.
Factory reset Wall Plug E/F
Resetting the device is not the recommended way of removing the device from the
Z-Wave network. Use reset procedure only if the primary controller is missing or
inoperable. Certain device removal can be achieved by the procedure of removing
described in “Adding/ removing the device”on page 6.
1) Make sure the device is powered.
2) Press and hold the B-button.
3) Wait for the LED ring to glow yellow (4th menu position).
4) Release the B-button.
5) Click the B-button once to confirm selection.
6) After few seconds the device will restart with factory settings, which is signalled with the red ring colour.
Please note that this is a user manual Wall Plug E/F from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wall Plug E/F and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.