The following is an overview of the user manual for the Z-Wave product Wall Plug (FGWPx-102)from FIBARO. To view other Z-Wave products and manuals from Fibaro follow that link.
Overview
Main features of FIBARO Wall Plug:
- Compatible with any Z-Wave or Z-Wave Plus Controller.
- Supports Z-Wave network Security Modes: S0 with AES-128 encryption and S2 with PRNG-based encryption.
- Extremely easy installation - simply plug the device into the mains socket.
- Works as a Z-Wave signal repeater.
- Active power and energy consumption metering for plugged device.
- Current value of the load and operating mode are indicated by the multi-color LED frame.
Security
As a Z-Wave Plus certified product, Wall Plug supports Z-Wave S2 security. The following security modes are directly supported:
Features
Fibaro describes Wall Plug as having the following features:
- Sensors
- Supported Meter Type
- Supported Notification Types
- Switch Load Capacity Current
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add the device to the Z-Wave network:
1. Plug the device into a socket nearby the main Z-Wave controller.
2. The LED ring will glow red signalling not being added (reset or remove the device otherwise).
3. Set the main controller in (security/non-security) add mode (see the controller’s manual).
4. Quickly, triple click the B-button located on the casing.
5. Wait for the adding process to end.
Successful adding will be confirmed by the Z-Wave controller’s message.
To remove the device from the Z-Wave network:
1. Plug the device into a socket nearby the main Z-Wave controller.
2. The LED ring will glow green signalling being added (removing is not necessary otherwise).
3. Set the main controller into remove mode (see the controller’s manual).
4. Quickly, triple click the B-button located on the casing.
5. Wait for the removing process to end.
Successful removing will be confirmed by the Z-Wave controller’s message.
FIBARO Wall Plug is powered with mains voltage so it is always awake.
Factory reset Wall Plug
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted.
1. Make sure the device is powered.
2. Press and hold the button.
3. Wait for the LED frame to glow yellow (3rd menu position).
4. Release the button.
5. Click the button once to confirm selection.
6. After few seconds the device will restart with factory settings, which is signaled with the red frame color.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Wall Plug from FIBARO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wall Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.