The following is an overview of the user manual for the Z-Wave product FlexNET Dongle (Z-FlexNET Dongle)from FLEX AUTOMATION. To view other Z-Wave products and manuals from Flex Automation follow that link.
Overview
It is a fully compatible with any Z-Wave enabled network. Z-Wave enabled devices displaying the Z-Wave logo can also be used with it regardless of the manufacturer. And ours can also be used in other manufacturer's Z-Wave enabled networks since FlexNET Dongle is used together with Flex Panels.
This Device is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure the signal is received by its intended destination by routing the signal around obstacles and radio dead spots.
Security
As a Z-Wave Plus certified product, FlexNET Dongle supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Flex Automation describes FlexNET Dongle as having the following features:
- Communications Connections
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Enter your Z-Wave Controller into Inclusion/Add Mode.
2. Press the Lighting Panel ""Scene1"" button more than 3 times within 1 second.
OR, to use NWI:
1. Enter your Z-Wave Controller into Inclusion/Add Mode.
2. Power on the FlexNET Dongle. It will be active during 4 seconds.
1. Enter your Z-Wave Controller into Exclusion/Remove Mode.
2. Press the Lighting Panel ""Scene1"" button more than 3 times within 1 second.
Factory reset FlexNET Dongle
To Reset to Factory Default send the following parameter:
Parameter: 15
Bytes: 01
Value: 255
Note: Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual FlexNET Dongle from FLEX AUTOMATION is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have FlexNET Dongle and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.