The following is an overview of the user manual for the Z-Wave product Smart dimmer (FX-D67A)from FLEX AUTOMATION. To view other Z-Wave products and manuals from Flex Automation follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart dimmer supports Z-Wave S2 security. The following security modes are directly supported:
Features
Flex Automation describes Smart dimmer as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. have your Z-Wave controller enter into Inclusion mode
2. press the dimmer socket button three times within 1.5 seconds
1. have your Z-Wave controller enter into Exclusion mode
2. press the dimmer socket button three times within 1.5 seconds
Factory reset Smart dimmer
1. Press your dimmer socket button four times within 1.5 seconds
2. the fourth time press and hold on the socket button for 5 seconds until socket LED button off
3. Use the ""RESET"" procedure only in the event that the network primary controller is missing or otherwise inoperable
Please note that this is a user manual Smart dimmer from FLEX AUTOMATION is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.