Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Forest Shuttle L Z-Wave (FS2Z) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Forest Shuttle L Z-Wave (FS2Z)from Forest Drapery Hardware. To view other Z-Wave products and manuals from Forest Drapery Hardware follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Forest Shuttle L Z-Wave
SKU Code
FS2Z
Description
Forest Shuttle L Z-Wave and the Forest motorized curtain track systems (FMS) make an unbeatable combination when it comes to noiseless operated motorized curtains. The smooth and silent running curtain track system can, in addition to remote operation, also be operated by hand. Thanks to Forest’s special Touch Impulse Technology, a gentle pull on the curtain is enough to activate the motor. The Forest Shuttle L Z-Wave also makes sure that your curtains will always hang beautifully smooth and supple. Opened as well as closed!
• Touch Impulse Technology, gently pulling the curtain will activate the motor.
• Integrated Emergency Control ensures manual operation of the curtain in case of power failure.
• Modular motor, different modules can be attached for various control options: Radio Frequency, Switch, Infrared, Domotics, Building/Hotel Automation, Serial Communication, Z-Wave, etc.
• Forest Shuttle L Z-Wave will have an internal Z-Wave receiver and BUS connection.
• Silent motor, speeds: 14 and 17 cm/sec., with slow start and slow stop.
• Full automatic setting of the limits.
• Stack-back position programmable to every desired setting.
• Forest Shuttle L Z-Wave has an integrated power supply.
• Motor pulley connects motor and FMS track. Also available in upside down version to conceal the motor into the ceiling.
• Available track lenghts: 5.80 meters and 7.00 meters. FMS track and components available in white and black.
Version #
1 was the version certified
Certification #
ZC10-15040008
Certified
2015-04-17T06:12:13.366
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Forest Shuttle L Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Forest Drapery Hardware describes Forest Shuttle L Z-Wave as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Press configuration button 3 times. LED3 is ON.
    Press and hold once more for 4 seconds.

    Factory reset Forest Shuttle L Z-Wave

    Press configuration button 25x times. LED 1 is ON. Press and hold once more for 4 seconds to confirm.
    Please use this procedure only when your network primary controller is missing or otherwise inoperable.

    Press configuration button 3 times. LED3 is ON.
    Press and hold once more for 4 seconds.

    Please note that this is a user manual Forest Shuttle L Z-Wave from Forest Drapery Hardware is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Forest Shuttle L Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.