The following is an overview of the user manual for the Z-Wave product Smart (HT-A10)from Gas Keeper. To view other Z-Wave products and manuals from Gas Keeper follow that link.
Overview
* This must be done at GAS valve and when closed. Press Timer UP button for 5 seconds till hearing beep once.
* You can set the time with Timer UP/DOWN button of the main device
* You can set the time for maximum 9 hours in unit of every 10 minutes
* GAS valve is closed automatically when the temperature reaches above to 65℃ inside of the gas circuit breaker
Security
As a Z-Wave Plus certified product, Smart supports Z-Wave S2 security. The following security modes are directly supported:
Features
Gas Keeper describes Smart as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
This must be done at GAS valve and when closed. Press Timer UP button for 5 seconds till hearing beep once.
This must be done at GAS valve and when closed. Press Timer UP button for 5 seconds till hearing beep once.
Wake up is released the Sleep mode open/close button operation.
GAS valve is closed automatically when the temperature reaches above to 65℃ inside of the gas circuit breaker
Factory reset Smart
This must be done at GAS valve and when closed. Press Timer UP button for 10 seconds till hearing beep once. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Smart from Gas Keeper is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.