The following is an overview of the user manual for the Z-Wave product 2 Button Hub Remote (34184 / ZW5307)from GE. To view other Z-Wave products and manuals from GE follow that link.
Overview
Enjoy a variety of placement options for your lighting control – utilize the included hardware and magnetic bracket for wall mounting, detach the remote for instant portability or pair the remote with a separate stand for convenient tabletop use. The hub remote also functions on a scalable system, giving you the freedom to start with one remote and add as many as you need. Take control of your lights with the Z-Wave 2 Button Portable Hub Remote.
Security
As a Z-Wave Plus certified product, 2 Button Hub Remote supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
GE describes 2 Button Hub Remote as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Battery Quantity
- Battery powered using CR2032 batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press either button once to wake up the device.
1. Follow the instructions for your Z-Wave certified hub to add a device to the Z-Wave network.
2. Once the hub is ready to add your device, press and release either button.
3. The LED will flash two (2) times when the remote sends add notification (NIF).
NOTE: Some Hubs will require an additional step for secure inclusion, when prompted scan the QR code on the back of the remote, or type in the 5-digit pin code located on the back of the remote.
4. Following the instructions for your Z-Wave certified hub assign actions for each button press. An action can be many different combinations of scenes, groups or events, and is greatly dependent on the hub you are using.
1. Follow the instructions for your Z-Wave certified hub to remove a device from the Z-Wave network.
2. Once the hub is ready to remove your device, press and release either button.
3. The LED will flash two (2) times when the remote sends remove notification (NIF).
Factory reset 2 Button Hub Remote
1. Press and release Button 1 ten times quickly. All button presses must be within 6 seconds.
2. The LED will flash five (5) times when completed successfully.
NOTE: This should only be used in the event your network's primary
controller/hub is missing or otherwise inoperable.
Please note that this is a user manual 2 Button Hub Remote from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 2 Button Hub Remote and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.