The following is an overview of the user manual for the Z-Wave product In-Wall Smart 1000W Dimmer (14299/ZW3006)from GE. To view other Z-Wave products and manuals from GE follow that link.
Overview
Z-Wave is the world’s largest ecosystem of inter operable smart home products. Z-Wave lighting controls provide an easy-to-install and affordable system to control lighting and small appliances in your home. Add GE Z-Wave lighting controls to a Z-Wave certified gateway to access and control your home from anywhere in the world using your smartphone, tablet or computer as a home automation command center. Never worry if you accidentally left the lights on because you can turn them off remotely or program your lights to go on/off at specific times. Create customized lighting scenes for any occasion such as a “go to sleep” scene or a “movie night” scene. Give the illusion that someone is home by programming the lights to turn on/off while you are away—perfect for deterring crime and adding additional security!"
Security
As a Z-Wave Plus certified product, In-Wall Smart 1000W Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
Features
GE describes In-Wall Smart 1000W Dimmer as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Neutral Wire Required
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Follow the instructions for your Z-Wave certified controller to
include a device to the Z-Wave network.
2. Once the controller is ready to add your device,
press and release the top or bottom of the wireless smart
switch (rocker) to add it in the network.
Please reference the controller’s manual for instructions.
1. Follow the instructions for your Z-Wave certified controller to
remove a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, press
and release the top or bottom of the wireless smart dimmer
(rocker) to remove it from the network.
Factory reset In-Wall Smart 1000W Dimmer
Quickly press ON (Top) button three (3) times then immediately
press the OFF (Bottom) button three (3) times. The LED will flash
ON/OFF 5 times when completed successfully.
NOTE: This should only be used in the event your network’s
primary controller is missing or otherwise inoperable.
Please note that this is a user manual In-Wall Smart 1000W Dimmer from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart 1000W Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.