Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Fan Control (14287/ZW4002) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Fan Control (14287/ZW4002)from GE. To view other Z-Wave products and manuals from GE follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Fan Control
SKU Code
14287/ZW4002
Description
Transform any home into a smart home with the GE Z-Wave Smart Fan Control. The in-wall fan control easily replaces any standard in-wall switch remotely controls a ceiling fan in your home and features a three-speed control system. Your home will be equipped with ultimate flexibility with the GE Z-Wave Smart Fan Control, capable of being used by itself or with up to four GE add-on switches. Screw terminal installation provides improved space efficiency when replacing existing switches and the integrated LED indicator light allows you to easily locate the switch in a dark room. The GE Z-Wave Smart Fan Control is compatible with any Z-Wave certified gateway, providing access to many popular home automation systems. Take control of your home lighting with GE Z-Wave Smart Lighting Controls!
Version #
HW: 255 FW: 5.20 was the version certified
Certification #
ZC10-16125338
Certified
2016-12-12T07:05:44.611423
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, In-Wall Smart Fan Control supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    GE describes In-Wall Smart Fan Control as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Neutral Wire Required
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, press and release the top or bottom of the wireless smart switch (rocker) to exclude it from the network.

    1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
    2. Once the controller is ready to include your device, press and release the top or bottom of the smart fan control switch (rocker) to include it in the network.
    3. Once your controller has confirmed the device has been included, refresh the Z-Wave network to optimize performance.

    Factory reset In-Wall Smart Fan Control

    1. Quickly press ON (Top) button three (3) times then immediately press the OFF (Bottom) button three (3) times. The LED will flash ON/OFF 5 times when completed successfully.
    Note: This should only be used in the event your network’s primary controller is missing or otherwise inoperable.

    Please note that this is a user manual In-Wall Smart Fan Control from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Fan Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.