Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Motion Switch (26931/ZW4006) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Motion Switch (26931/ZW4006)from GE. To view other Z-Wave products and manuals from GE follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Motion Switch
SKU Code
26931/ZW4006
Description
Transform any home into a smart home with the GE In-Wall Smart Motion Switch. This Z-Wave device replaces you current light switch using your existing wiring and provides Z-Wave wireless control of overhead lighting. The switch enables wireless control of On/OFF functions of incandescent, LED, xenon, halogen and fluorescent lighting. Not only does it act as a switch but the GE In-Wall Smart Motion Switch has a built in PIR sensor which can control the local and be set in occupancy or vacancy mode.
Version #
HW: 255 FW: 5.56 was the version certified
Certification #
ZC10-16105294
Certified
2016-10-27T15:59:35.968622
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, In-Wall Smart Motion Switch supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    GE describes In-Wall Smart Motion Switch as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Sensors
    • Neutral Wire Required
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified
    controller to include the smart switch to the
    Z-Wave network.
    2. Once the controller is ready to include your smart
    switch, press and release the top or bottom button
    on the smart switch to include it in the network.

    1. Follow the instructions for your Z-Wave certified
    controller to exclude a device from the Z-Wave
    network.
    2. Once the controller is ready to exclude your device,
    press and release the top or bottom button on the
    smart switch to exclude it from the network.

    Factory reset In-Wall Smart Motion Switch

    Press and release the top button ten times.
    Note: This should only be used in the event your
    network’s primary controller is missing or otherwise
    inoperable.

    Please note that this is a user manual In-Wall Smart Motion Switch from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Motion Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.