The following is an overview of the user manual for the Z-Wave product In-Wall Smart Outlet (14286/ZW1001)from GE. To view other Z-Wave products and manuals from GE follow that link.
Overview
Security
As a Z-Wave Plus certified product, In-Wall Smart Outlet supports Z-Wave S2 security. The following security modes are directly supported:
Features
GE describes In-Wall Smart Outlet as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Follow the instructions for your Z-Wave certified
controller to add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press and
release the Program Button to add it in the network.
1. Follow the instructions for your Z-Wave certified controller to
remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press and
release the manual/program button on the smart dimmer to
remove it from the network.
Factory reset In-Wall Smart Outlet
1. Press and hold the button for at least 3 seconds. The LED light
will blink 5 times to confirm.
NOTE: This should only be used in the event your network’s primary
controller is missing or otherwise inoperable.
Please note that this is a user manual In-Wall Smart Outlet from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Outlet and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.