Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Switch (14291 (ZW4005)) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Switch (14291 (ZW4005))from GE. To view other Z-Wave products and manuals from GE follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Switch
SKU Code
14291 (ZW4005)
Description
Transform any home into a smart home with the GE Z-Wave Smart Lighting Control In-Wall Smart Switch. The on/off switch replaces your current light switch, uses your existing wiring, and provides Z-Wave wireless and in-wall control of overhead lighting. The switch enables wireless control of on/off functions of direct wire incandescent, LED, xenon, halogen and fluorescent lighting. Providing ultimate flexibility, the GE Z-Wave Smart Lighting Control On/Off Switch allows you to operate the switch by itself or easily integrate the switch with two-way, three-way or four-way wiring configurations by adding the GE Add-On switch. Single pole wiring configuration turns the light or appliance on/off from one location. Three-way wiring configuration turns the light on/off from two separate locations. Four-way wiring configuration turns the light on/off from three separate locations. The GE Add-On Switch is required for Three-way or Four-way installations. The lighting control includes a blue LED indicator light to easily locate the switch in a dark room. Take control of your home lighting with GE Z-Wave Smart Lighting Controls!
Version #
HW: 255 was the version certified
Certification #
ZC10-15080016
Certified
2015-08-18T14:15:32.4266
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, In-Wall Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    GE describes In-Wall Smart Switch as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-wave certified controller to include a device to the Z-wave network.
    2. Once the controller is ready to include your device, press and release the top or bottom of the wireless smart switch(rocker) to include it in the network.

    1. Follow the instructions for your Z-wave certified controller to exclude a device from the Z-wave network.
    2. Once the controller is ready to Exclude your device, press and release the top or bottom of the wireless smart switch(rocker) to exclude it from the network.

    Factory reset In-Wall Smart Switch

    1. Quickly press ON (Top) button three (3) times then immediately press the OFF (Bottom) button three (3) times. The LED will flash ON/OFF 5 times when completed successfully.
    Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable.

    Please note that this is a user manual In-Wall Smart Switch from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.