Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Toggle Dimmer (14295/ZW3004) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Toggle Dimmer (14295/ZW3004)from GE. To view other Z-Wave products and manuals from GE follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Toggle Dimmer
SKU Code
14295/ZW3004
Description
Transform any home into a smart home with the GE Z-Wave In-Wall Smart Toggle Dimmer. The dimmer enables wireless control of on/off and dim functions of hard-wired dimmable LED/CFL and incandescent lighting. The dimmer replaces your current light switch, uses your existing wiring, and provides Z-Wave wireless and in-wall control of overhead lighting. Use the dimmer feature to customize the lighting output and create the perfect ambiance for any room. Providing ultimate flexibility, the In-Wall Smart Dimmer allows you to operate the switch by itself or easily integrate the switch three-way or four-way wiring configurations by adding the GE Add-On Switch. Single Pole wiring configuration controls the light from one location. Three-way wiring configuration controls the light from two separate locations. Four-way wiring configuration controls the light from three separate locations. The GE Add-On Switch is required for three-way or four-way installations. Take control of your home lighting with GE Z-Wave Wireless Lighting Controls!
Version #
HW: 255 FW: 5.21 was the version certified
Certification #
ZC10-16105295
Certified
2016-10-27T16:08:35.205594
Z-Wave Version
6.51.08

Security

As a Z-Wave Plus certified product, In-Wall Smart Toggle Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    GE describes In-Wall Smart Toggle Dimmer as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Neutral Wire Required
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to
    include a device to the Z-Wave network.
    2. Once the controller is ready to include your device, press
    and release the top or bottom of the wireless smart dimmer
    (rocker) to include it in the network.

    1. Follow the instructions for your Z-Wave certified controller to
    exclude a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, press
    and release the top or bottom of the wireless smart dimmer
    (rocker) to exclude it from the network.

    Factory reset In-Wall Smart Toggle Dimmer

    1. Quickly press ON (up) button (3) times then immediately press the OFF (down) button (3) times.
    Note: This should only be used in the even your network's primary controller is missing or otherwise inoperable.

    Please note that this is a user manual In-Wall Smart Toggle Dimmer from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Toggle Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.