Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Toggle Switch (120/277VAC) (43074/ZW4009DV) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Toggle Switch (120/277VAC) (43074/ZW4009DV)from GE. To view other Z-Wave products and manuals from GE follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Toggle Switch (120/277VAC)
SKU Code
43074/ZW4009DV
Description
In-Wall Smart Toggle Switch (120/277VAC) with QuickFit and SimpleWire enhancements. Revolutionary QuickFit design features a housing depth that is up to 20 percent smaller than the previous Z-Wave models. This reduced size coupled with the elimination of heat taps provides a better fit in older style boxes and multi-gang configurations. SimpleWire technology allows line and load to automatically be configured with auto-sensing line-load terminals. All of this is coupled with Z-Wave S2 and Smart Start allows for effortless installation while being safer than ever!
Version #
HW: 255 FW: 5.53 was the version certified
Certification #
ZC10-19056489
Certified
2019-05-15T17:15:45.377327
Z-Wave Version
6.81.03

Security

As a Z-Wave Plus certified product, In-Wall Smart Toggle Switch (120/277VAC) supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

GE describes In-Wall Smart Toggle Switch (120/277VAC) as having the following features:

  • Neutral Wire Required
  • Z-Wave Scene Type
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Factory reset In-Wall Smart Toggle Switch (120/277VAC)

1. Quickly press ON (top) button three times then immediately
press the OFF (Bottom) button three times. The LED will
flash ON/OFF five times when completed successfully.
Note: This should only be used if your network’s primary
controller is missing or otherwise inoperable.

1. Follow the instructions for your Z-Wave certified
controller to add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press and
release the top or bottom of the wireless smart switch (rocker).

1. Follow the instructions for your Z-Wave certified controller
to remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press and
release the top or bottom of the wireless smart switch (rocker).

Please note that this is a user manual In-Wall Smart Toggle Switch (120/277VAC) from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Toggle Switch (120/277VAC) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.